- Compare methods of computing lower of cost or net realizable value
Net realizable value (NRV) sounds complicated, and a lot of accountants may still use the old term: Lower of Cost or Market (LCM).
However, in July 2015, the Financial Accounting Standards Board (FASB) adopted ASU 2015-11, FASB’s Accounting Standards Codification (ASC) Topic 330, Inventory, that replaced LCM with LCNRV.
Lower of cost or market (old rule)
The old rule (that still applies to entities that use LIFO or a retail method of inventory measurement) required entities to measure inventory at the LCM. The term market referred to either replacement cost, net realizable value (commonly called “the ceiling”), or net realizable value (NRV) less an approximately normal profit margin (commonly called “the floor”).
In other words, market was the price at which you could currently buy it from your suppliers. Except, when you were doing the LCM calculation, if that market price was higher than net realizable value (NRV), you had to use NRV. If the market price was lower than NRV minus a normal profit margin, you had to use NRV minus a normal profit margin.
Lower of cost or NRV (new rule)
The new rule, LCNRV, was designed to simplify this calculation. NRV is the estimated selling price in the ordinary course of business, minus costs of completion, disposal, and transportation.
Say Geyer Co. bought 200 Rel 5 HQ Speakers five years ago for $110 each and sold 90 right off the bat, but has only sold 10 more in the past two years for $70. There are still a hundred on hand, costs using FIFO, but the speakers are obsolete and management feels they can sell them with some slight modifications to each one that cost $20 each.
So, the NRV is:
| Sales price | $70 |
|---|---|
| Costs to complete | 20 |
| NRV Double line | $50 Double line |
- Cost: $110.00
- Replacement Cost: $60
- NRV: $50
So under the old rule of LCM, replacement cost (what our wholesale distributor sells to them to us for) would be the ceiling. Let’s also say we would normally mark them up and expect to make about $20 on the sale, so the floor, the lowest we could adjust them to, would be $30. If we lowered the cost to $30 on our books and sold them for $70 minus the $20 it takes to make them saleable, we’d make a normal profit.
| cost | Rel 5 | HQ Speakers | 110.00 |
|---|---|---|---|
| NRV | Rel 5 | HQ Speakers | 50.00 |
| replacement cost | Rel 5 | HQ Speakers | 60.00 |
| NRV—normal profit margin | Rel 5 | HQ Speakers | 30.00 |
Under the old rule that still applies to LIFO and retail inventory methods, the item could be written down to market because it is lower than the historical cost of $110. Market is somewhere between the ceiling and the floor: between $50 and $30. Since the replacement cost is over the ceiling, we’d use the $50 NRV for market.
If the replacement cost had been $20, the most we could write the inventory down to would be the floor of $30.
If the replacement cost had been $45, we would write the inventory down to $45.
Under the new rule, which Geyer would be using because it is using FIFO cost flow assumption, the calculation is actually simpler: NRV. So, $50.
As a result of our analysis, we would write down the cost of Rel 5 HQ Speakers, highlighted below in yellow, by $6,000 so the new cost on our books is $50 each.
| Geyer, Co. | |||||||
| 12/31/20XX | |||||||
| Product ID | Description | Cost | Quantity in Stock | Total Cost (FIFO) | NRV | LCNRV | Total at LCM |
|---|---|---|---|---|---|---|---|
| A101 | Wiring harness | 99.000 | 30 | 2,970.00 | 102.00 | 99.00 | 2,970.00 |
| CAB 500 | HQ Speakers | 58.000 | 500 | 29,000.00 | 50.00 | 50.00 | 25,000.00 |
| CAB 600 | HQ Speakers | 99.000 | 15 | 1,485.00 | 50.00 | 50.00 | 750.00 |
| MMM 333 | GPS enabled sound system | 1,255.500 | 64 | 80,352.00 | 2,625.00 | 1,255.50 | 80,352.00 |
| Rel 5 | HQ Speakers | 110.000 | 100 | 11,000.00 | 50.00 | 50.00 | 5,000.00 |
| RFS-212 | GPS enabled sound system | 650.000 | 150 | 97,500.00 | 400.00 | 400.00 | 60,000.00 |
| XPS-101 | GPS enabled sound system | 102.375 | 160 | 16,380.00 | 80.00 | 80.00 | 12,800.00 |
| Total Inventory FIFO | $ 238,687.00 | $ 186,872.00 | |||||
In the next section, we’ll look at how to adjust total inventory, but first to review:
From ASU 2015-11:
Inventory Measured Using Any Method Other Than LIFO or the Retail Inventory Method
330-10-35-1B Inventory measured using any method other than LIFO or the retail inventory method (for example, inventory measured using first-in, first-out (FIFO) or average cost) shall be measured at the lower of cost and net realizable value. When evidence exists that the net realizable value of inventory is lower than its cost, the difference shall be recognized as a loss in earnings in the period in which it occurs. That loss may be required, for example, due to damage, physical deterioration, obsolescence, changes in price levels, or other causes.
By adjusting the inventory down, the balance sheet value of the asset, Merchandise Inventory, is restated at a more conservative number. Notice that we never adjust inventory up to fair market value, only downward.
One final note: ASU 2015-11, FASB’s Accounting Standards Codification (ASC) Topic 330 carved out an exception to the new rule for LIFO and retail inventory methods. One of the simplest versions of the retail inventory method calculates ending inventory by totaling the value of goods that are available for sale, which includes beginning inventory and any new purchases of inventory. Total sales are multiplied by the cost-to-retail ratio (or the percentage by which goods are marked up from their wholesale purchase price to their retail sales price) in order to get an estimate of COGS.
Using the formula:
[latex]\text{Beginning inventory}+\text{purchases}-\text{ending inventory}=\text{COGS}[/latex]
Modified slightly:
[latex]\text{Beginning inventory}+\text{purchases}-\text{COGS}=\text{ending inventory}[/latex]
A large company like Home Depot that has a consistent mark-up can reasonably estimate ending inventory. Home Depot undoubtedly uses a more sophisticated version of this calculation, but the basic idea would be the same.
Because the estimated cost of ending inventory is based on current prices, this method approximates FIFO at LCM.
Let’s see how companies apply this conservative rule to inventories.